New 12.5, nasty burr in chamber?

Moderators: e292644, blueeyedwolf

Post Reply
User avatar
friedchickenwaffles
II
Posts: 6
Joined: Wed Aug 15, 2018 3:50 pm
Country: USA
Location: PA

Wed Aug 15, 2018 4:01 pm

Just got the Lil guy in, and was giving a full once over QC check. Got a light in the chamber and I see a pretty rough area in the 1-3 o'clock region of the chamber wall. Send it back? https://imgur.com/dcfyL74


User avatar
e292644
Site Admin
Posts: 420
Joined: Thu Apr 20, 2017 5:47 pm
Country: USA
Location: AZ
Contact:

Wed Aug 15, 2018 6:01 pm

Wow, that doesn't look right, can't really tell what's going on there but it's a good idea to replace it.
User avatar
Iamscotticus
L
Posts: 85
Joined: Thu Nov 16, 2017 9:00 pm

Wed Aug 15, 2018 6:07 pm

I would put a nylon .35 bore or .223 chamber brush on a rod and a drill and run it in there to see what happens.
Could this be a coating buildup from production?
A have read from a lot of guys, and for myself that the first rounds are really tight, but eventually work out.

As for sending it back, Steve Dittner at Wolf is golden. He will take care of you.
User avatar
friedchickenwaffles
II
Posts: 6
Joined: Wed Aug 15, 2018 3:50 pm
Country: USA
Location: PA

Wed Aug 15, 2018 6:24 pm

The fact that it's in a pretty singular are and not just some shmutz spread around the whole thing leads me to think it's buggered up chamber wall. I don't want to mess with it at all, just let it as is and send it back in.
Post Reply