T91 Polymer Handguard Tri-Rail is HERE!

Keymod Handguard, Sights, and More...

Moderators: e292644, blueeyedwolf

Post Reply
User avatar
e292644
Site Admin
Posts: 396
Joined: Thu Apr 20, 2017 5:47 pm
Country: USA
Location: AZ
Contact:

Tue Dec 03, 2019 9:47 pm

Tri Picatinny Rail Mount design for tactical T91 upper build.
Machined from 6063-T6 aluminum.
Limited Inventory.


Tir-Rail-5.png
Tir-Rail-1.png
Tir-Rail-2.png
You do not have the required permissions to view the files attached to this post.


User avatar
apex
II
Posts: 13
Joined: Sun Dec 09, 2018 1:59 pm
Country: USA
Location: MD

Tue Dec 03, 2019 10:05 pm

@onion8@ @onion14@
YYYYYEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEESSSSSSSSSSSSSSSSSSSSSSSS
User avatar
TinCuda
I
Posts: 1
Joined: Mon Sep 23, 2019 5:28 pm
Country: usa
Location: TX

Tue Dec 03, 2019 11:35 pm

Just ordered one. Can't wait! Thank you very much for making this happen!
User avatar
Diezel
I
Posts: 2
Joined: Sun Sep 23, 2018 3:49 am
Country: USA
Location: MD

Sat Dec 07, 2019 3:56 pm

Got mine installed today. Looking slick.
User avatar
brancheey
I
Posts: 1
Joined: Tue Dec 03, 2019 9:30 am
Country: USA
Location: GA

Mon Dec 30, 2019 3:39 pm

I just purchased two of these T91 Polymer Handguard Tri-Rail
SKU T91HTR01 , used screws that they sent "2 screws" well it wobbles does not fully seat and screws hits the piston tubes both uppers the same hope I didn't damage either , removed the screws and check both pistons for damage. I think they are either the wrongs screws or they are just too long...

kinda pissed for $138!
User avatar
e292644
Site Admin
Posts: 396
Joined: Thu Apr 20, 2017 5:47 pm
Country: USA
Location: AZ
Contact:

Mon Dec 30, 2019 10:34 pm

Please share some photos for the issues you encounter.

The screws is about 1/2" long, shouldn't go over the hand guard itself.
Here's the photo we've tested after Tri-Rail installed from inside of the upper hand guard.
Inner-Handguard.jpg
Tri-Rail-Screws.jpg
If you are not satisfied with it, we can either replace them or offer you full refund.
brancheey wrote:
Mon Dec 30, 2019 3:39 pm
I just purchased two of these T91 Polymer Handguard Tri-Rail
SKU T91HTR01 , used screws that they sent "2 screws" well it wobbles does not fully seat and screws hits the piston tubes both uppers the same hope I didn't damage either , removed the screws and check both pistons for damage. I think they are either the wrongs screws or they are just too long...

kinda pissed for $138!
You do not have the required permissions to view the files attached to this post.
Post Reply