T91 clone new pics

Moderators: blueeyedwolf, e292644

Post Reply
User avatar
akguy1985
II
Posts: 23
Joined: Tue Aug 08, 2017 4:13 am

Wed Oct 10, 2018 5:53 am

Here are a couple new pics of my T91 clone. I had a local gunsmith install the correct gas block on my upper, took a total of 25 days from when I dropped it off. The gas port in the barrel was allegedly undersized and would not cycle properly, I found the correct gas port spec and gunsmith enlarged the port and now functions properly with a standard buffer. The one last thing I need is to complete my 80% lower and it will be totally done. Also shown is a T91 magazine with the witness holes, all T91 parts courtesy of T91 tactical. @onion14@

Image
Image
Image
Image


User avatar
darkarmour
II
Posts: 15
Joined: Thu Mar 22, 2018 11:58 pm
Country: USA
Location: PA

Wed Oct 10, 2018 3:51 pm

Looks good. You might want to consider replacing that roll pin (pinning the gas block to the barrel) with a more secure solution like a tapered pin or even a regular steel pin. It's probably not critical unless you want to be absolutely sure that the front sight post doesn't wiggle even a little bit.
Post Reply