Remove disassembly loop and add front swivel ring.

Moderators: e292644, blueeyedwolf

Post Reply
User avatar
slim934
I
Posts: 4
Joined: Tue Jan 22, 2019 5:23 pm
Country: USA
Location: SC

Sat Mar 16, 2019 11:31 am

I am looking to add the dedicated front swing swivel ring. Is there any good direction for how to remove the current loop arrangement inorder to install it?


User avatar
TNYankee
I
Posts: 2
Joined: Sat Feb 23, 2019 9:11 am
Country: USA
Location: TN

Sat Mar 16, 2019 5:25 pm

It's simple:
1. Clear the weapon, remove the gas piston assembly (part 7) per manual instructions (http://wolfammo.com/pdf/WOLF-A1-operator-manual.pdf).

2. Use a roll pin punch to drive out the approximately 1/8" diameter locking collar (roll) pin (part 4H) that retains the locking collar (part 4G) on gas piston retainer (part 4D). It's located on the ejection port side of the gas block. Go slow, as the gas piston retainer assembly is under mild spring pressure.

3. Once the rin is removed, pull it all apart and swap out the collar (part 4E) with the front sight sling swivel ring.

4. Reassemble in reverse order; using a second roll pin punch as a slave pin helps.

Part numbers are taken from parts diagram in manual.
User avatar
NavyChief
I
Posts: 2
Joined: Tue Mar 31, 2020 1:48 pm
Country: USA
Location: Arizona

Sat May 02, 2020 8:15 am

Honestly, it's really very simple.

Just use the directions posted above, and it'll work out . BUT I removed the Gas Piston Assembly prior to doing it.

Did mine, and I was done in about 5 minutes. Could have been done faster, if I didn't explore the inner workings of the Front Sight post area.

And also, if I didn't try to Re-Think such a SIMPLE procedure.

Now my MagPul Sling clamps on just so easy.
Post Reply