Here are a couple new pics of my T91 clone. I had a local gunsmith install the correct gas block on my upper, took a total of 25 days from when I dropped it off. The gas port in the barrel was allegedly undersized and would not cycle properly, I found the correct gas port spec and gunsmith enlarged the port and now functions properly with a standard buffer. The one last thing I need is to complete my 80% lower and it will be totally done. Also shown is a T91 magazine with the witness holes, all T91 parts courtesy of T91 tactical.
2 posts • Page 1 of 1
- Posts: 15
- Joined: Thu Mar 22, 2018 11:58 pm
- Country: USA
- Location: PA
Looks good. You might want to consider replacing that roll pin (pinning the gas block to the barrel) with a more secure solution like a tapered pin or even a regular steel pin. It's probably not critical unless you want to be absolutely sure that the front sight post doesn't wiggle even a little bit.