T91 80% Lower Anodizing Problem

Moderators: blueeyedwolf, e292644

Post Reply
User avatar
JTM20
II
Posts: 8
Joined: Sat Mar 31, 2018 2:37 pm
Country: USA
Location: MD

Thu Oct 10, 2019 4:58 am

I finally got around to sending my 80% T91 lower to be hard coat anodized. It came out great, except the center of the "rifle" character came out.

Anyone else seen something similar?

20191010_074458.jpg
You do not have the required permissions to view the files attached to this post.


User avatar
darkest2000
II
Posts: 18
Joined: Thu Jun 01, 2017 4:31 pm

Sat Oct 12, 2019 10:17 am

It may have eroded away during the anodizing process, it can happen with type III anodizing especially if your doing one off parts rather than an entire batch of similar parts.

By the way it still came out looking great, who did you use I’d you don’t mind me asking?
User avatar
JTM20
II
Posts: 8
Joined: Sat Mar 31, 2018 2:37 pm
Country: USA
Location: MD

Sat Oct 12, 2019 10:26 am

SNF Finishing

That's probably what happened, the lines there were very fine. Or the sand blast was too aggressive.

Either way, it looks great besides that spot. Great color match to my uppers.
Post Reply